Standard Resistor Network. 180 ohm, slower response for flat track scale racing
Miniature plug in circuit board allows racer to change the overall band resistance to best suit the type of motor being used. The higher the listed ohms the slower the band response and the lower the listed ohms the faster the band response. The standard networks are soldered and ready to install and have the same value resistance per band. The custom networks have miniature sockets and various values of resistors that can be mixed and matched to get the desired band response. All controllers and modules come standard with a 148 ohm network. As a comparison, our 15 band Fanatic controllers have 150 ohms of total resistance.
Note: the network resistance shown, 180 ohms for example, is the resistance needed to control our transistor circuit and should not be confused with the ohms rating on a typical Parma type resistor.
|Unit of Measure||EACH|